Fslabs a320 manual7/1/2023 I tried doing it yesterday but when I pressed the brakes, they would only stay pressed. Can someone point me in the right direction? FSUIPC is a great tool but seems to have a lot more than I need at this point so if there are any bullets or steps to do this that would be appreciated. I've seen some steps and I think I have it right but want to make sure this is the way to go.ġ) remove all axis controls I don't want P3D controlling for the stick and rudder (make sure I keep stick enabled in P3d if I don't want it to be completely shut down)Ģ) go into FSUIPC and go to axis - from there load the current profile I have set up for the FSLabs planeĪfter this step, I am a little lost as to what I need to do to correctly get this set. I also want them to be correctly calibrated via FSUIPC. I want to keep my throttle as is and also allow the button assignments on my stick to keep my views set up through Chaseplane. I was wondering if someone can point me in the right direction as to how to properly set up my stick axis' for elevator and aileron control, twist axis on the stick for ground steering, as well as rudder control.
0 Comments
Leave a Reply. |